Home of the CB-FET, CB-DNA, and CB-MECH Mods, and DNA Themes for DNA Colour chips.
About
This section of my site contains all the info about my custom Unregulated Mosfet, Full Mechanical, and Regulated Mods.
These are all designed to be printable with minimal support material, on a home FDM Printer, you can use services like Shapeways
to get them printed, just bear in mind that because of how they were designed, it will likely be a bit more expensive than other designs.
CB-FET
The CB-FET is a unregulated Mosfet box mod, available as single/dual 18650 or single/dual 21700, the dual battery configurations are parallel
mods, and utilise a ModMaker Clickfet N-Channel Mosfet board, as such, they come with some nice safetynets, like low resistance protection,
low votage protection, and reverse polarity protection.
Currently the CB-FET is a standard box mod, and a Squonk version is in the works.
Keep in mind while this is a semi-mechanical mod, there is no regulation of power like a fully-mechanical mod, and will need a good understanding
of Ohms-Law and know your battery's limits. DO NOT STRESS YOUR CELLS.
You can find all of the Files, Instructions to build the CB-FET, and a Bill of Materials by pressing "Read More" below or by using the navigation above.
The CB-MECH is a fully mechanical box mod, these are as simple as a Mod can get, a battery, contacts, and a 510 connector.
There are no safeties and no power regulation, and as such I only recommend building one if you are confident in your atomiser
builds, have a good understanding of Ohms-Law, and are completely sure that your batteries are not being stressed out by a build.
once again, DO NOT STRESS YOUR CELLS
Currently the CB-MECH is in development and will only be available in Single Battery configurations.
You can find all of the Files, Instructions to build the CB-MECH, and a Bill of Materials by pressing "Read More" below or by using the navigation above.
CB-DNA
The CB-DNA is a DNA Colour powered Regulated Box Mod, with Single 18650 and Dual Parallel 18650 configurations for the DNA 75C,
Single 21700 for the DNA 100C, and Dual Series 18650 for the DNA 250C.
These are currently in development and will release when i feel they are ready.
You can find all of the Files, Instructions to build the CB-DNA, and a Bill of Materials by pressing "Read More" below or by using the navigation above.
CB-TAB
The CB-TAB is a DNA 75C Build Tab, used to remove hotspots from coils and test fire builds when wicked, the DNA75C will give an accurate ohm readout
allowing you to verify your builds are at the ohm rating you desire
This is currently in development and will release when i feel they are ready.
You can find all of the Files, Instructions to build the CB-TAB, and a Bill of Materials by pressing "Read More" below or by using the navigation above.